4/29/2024 0 Comments Loopback ping failedThat being said, yes I have about 6 other devices on this network that can all communicate fine both with each other and with the Internet.Į.g. In this instance, 10.0.0.138 is the default address of a ZyXEL router. The gateway address has to be specified either way. There is - as you said - no technical reason why the gateway should be the lowest or highest address on the subnet, it is merely done by convention. The server is now up and running with a DHCP supplied IP address. The static IP address information can now be disregarded. Probably not the full issue (a bad gateway would still allow for local access to other devices on your subnet), but a symptom of other issues.ĭo you have an IP config for another machine on that network that is working? While this is technically possible, it is very illogical and someone would have had to go out of their way to set this irregular GW IP. If using Windows, open the Command Prompt. The Ping command operates virtually identically on all systems. Every operating system has a command line interface that will allow you to run the Ping command. See PING parameters to fine-tune the PING command to get the most accurate results. To test network connectivity with ping: Open the Command Prompt or Terminal. For IPv6: PING ::1 or PING IPV6-LOOPBACK. RX bytes:560 (560.0 B) TX bytes:560 (560.0 B) To ping the loopback interface on your system to troubleshoot the problem, follow these steps: At the command line, type these commands: For IPv4: PING 127.0.0.1 or PING LOOPBACK. TX packets:8 errors:0 dropped:0 overruns:0 carrier:0 RX packets:8 errors:0 dropped:0 overruns:0 frame:0 TX packets:258 errors:0 dropped:0 overruns:0 carrier:0 RX packets:241 errors:0 dropped:0 overruns:0 frame:0 UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1 Supported link modes: 10baseT/Half 10baseT/FullĪdvertised link modes: 10baseT/Half 10baseT/FullĮth0 Link encap:Ethernet HWaddr 00:1e:67:23:4b:b3 Name resolution fails now too, by the ethtool eth0 Plugins are out, and I've rebooted again. wget does not work (which I guess is why the influencer-plugins are having problems).Ping from the server does not work (not to any devices on the network, including the router). ![]() telnet to the server works fine, but the logon prompt takes about a minute to show up.The Dropbox plugin works fine and even updates files from the Internet.The Samba service and shares work fine.I can ping the server fine from my other computers.I've removed all the plugins except for dropbox, since this still works (strangely enough), but this doesn't seem to solve the more basic connection issues I'm having. Rebooting also took ages (I think it was waiting for each plugin-installation to time out). I tried reinstalling them, but this failed too. (influencer versions)) were not functioning properly. (For now, anyway.)Īfter trying (and failing) to install SimpleFeatures, I noticed that my other plugins (sabnzbd, sickbeard, headphones etc. This is a compound issue, but I think the problem of pinging out from the server is at least a clue to the root cause, so I'm using that as the thread title.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |